SPAREPARTS O-RING STABILIZER : SMALL-MEDIUM
The SpareParts Hardwear O'ring Stabilisers are a nifty accessory that offer support and stability for a variety of dildos. These versatile stabilisers have been designed to create a larger base for small dildos and support for heavier bases.
- Made in the US
- Support for heavier dildo bases
- Support for smaller dildos
- Use with strap-on harness
- Fits dildos measuring 1 – 1.8 inches in width
- Easy to use
Designed by Spareparts Hardwear and made in the US, the O’ring Stabilisers create additional support and stability to the dildo when using a strap-on harness.
When used with a small dildo with a diameter that measures less than an inch, an o’ring stabiliser adds stability, whilst creating a bigger base which helps keep it securely in place when using a harness. When used with heavier dildos, the o’ring stabiliser acts as a support device.
To use, simply wet the inside opening of the o’ring stabiliser with water and slide it down the shaft of the dildo.
The O’ring Stabiliser is available in 2 sizes, This small to medium size accommodates dildos measuring 1 to 1.8 inch (2.5 - 4.5 cm) in width. All dildos sold on the Wet For Her website are compatible with the O’ring Stabiliser.
Clean after each use - Hand Wash only
Vibrating devices, cosmetics and products accessories are not exchangeable. If you think you have received a defective device, please contact us at support(@)wetforher.zendesk.com